Volume 13, Issue 4 (Journal of Soil and Plant Interactions 2023)
2023, 13(4): 105-117 |
Back to browse issues page
Irrigation and Drainage Engineering, Agricultural Engineering, Research Institute (AERI), Agricultural Research, Education and Extension Organization (AREEO), Karaj, Iran.
Abstract: (1035 Views)
Abstract
The present study was conducted in the research field of Seed and Plant Improvement Research Institute to investigate the effect of fertilizer amount in three levels (N1: 100, N2: 80, N3: 60 percent of fertilizer requirement) and two splitting methods (T1: four equal usage including 4-6 leaf stage, 10 leaf stage, reproduction stage and inoculation stage and T2: three equal usage including 4-6 leaf stage, 10 leaf stage and reproduction stage) on corn yield and yield components. The treatments were compared with control which is the common fertilizer usage in the region. Based on the results, the highest grain yield in the first year was obtained in T1N1, T1N3 and control treatments. Grain yield in T2 was less than T1. Nitrogen splitting in T2 compared to T1 reduced the nitrogen content and grain protein content by 12.8% and 13%, respectively. Splitting of nitrogen fertilizer in three stages caused more nitrogen uptake by crop leaves at the end of the growing season; however, this did not increase grain yield and seed quality. Except for the control, no significant changes in soil nitrogen content were observed from surface to depth. The highest percentage of soil nitrogen was observed in the two layers of 0-20 and 20-40 cm in the control. The lowest content of soil nitrogen was observed in in T2N3 treatment with 24.5% (0-20 cm) and 24.5% (20-40 cm) more than control, respectively. The highest and lowest nitrogen losses in runoff were observed in T1N1 (23%) and control (7%), respectively. With the reduction of fertilizer application, runoff losses also decreased; in the T1N2 and T1N3 treatments, this reduction was 9% and 14%, respectively. Overall, T1N2 is recommended as a suitable treatment due to the high grain yield, seed quality and reduction of nitrogen losses.
Background and Objectives: Although reducing the amount of nitrogen fertilizer can lessen the negative effects of its losses, but it reduces the yield and yield components of crops, including corn (1). Therefore, nitrogen splitting is considered as a suitable solution to combat the reduction of nitrogen fertilizer consumption (2). Corn is one of the most important grains in the world, which can be cultivated in most regions of the world. As the third most consumed grain in the world, this crop has a share of about 2.8% of grain consumption in the world. This crop is cultivated in most provinces of the country and is sensitive to nitrogen (3) consumption. Increasing available nitrogen improves seed yield and growth indicators.
Methods: To achieve this goal, the present study was carried out in the research field of Seed and Plant Improvement Research Institute on fertilizer amount in three levels (N1: 100, N2: 80, N3: 60 percent of fertilizer requirement) and two splitting methods (T1: Four equal usage including 4-6 leaf stage, 10 leaf stage, reproduction stage and inoculation stage and T2: three equal usage including 4-6 leaf stage, 10 leaf stage and reproduction stage) in two years. These treatments were compared with control which was the traditional fertilizer usage in the region. The planting operation of this variety was done in May every year with a density of 80 thousand plants per hectare. Irrigation was done based on the complete water requirement of the plant. To determine the amount of irrigation water, evaporation from the surface of class A pan and application of pan and plant coefficients were considered. Irrigation was done in the form of furrows and according to the custom of the region, with a cycle of seven days. For this purpose, five wells were considered for each treatment. Three middle furrows were considered for harvest and two side furrows were considered for the marginal effect. The distance between the stacks was 75 cm and their length were 115 meters. Irrigation treatments were applied 5 days after planting.
Results: The highest grain yield in the first year was obtained in T1N1, T1N3 and control treatments. Grain yield in T2 was less than T1. Nitrogen splitting in T2 compared to T1 reduced nitrogen and grain protein by 12.8% and 13%, respectively. Splitting of nitrogen fertilizer in three stages caused more nitrogen uptake by crop leaves at the end of the growing season; however, this did not increase grain yield and seed quality. Except for the control, no significant changes in soil nitrogen content were observed from surface to depth. The highest soil nitrogen content was observed in the two layers of 0-20 and 20-40 cm in the control. The lowest soil nitrogen content was observed in T2N3 treatment with 24.5% (0-20 cm) and 24.5% (20-40 cm) more than control, respectively. The highest and lowest nitrogen losses in runoff were observed in T1N1 (23%) and control (7%), respectively. With the reduction of fertilizer application, runoff losses also decreased, so that in T1N2 and T1N3 treatments, this reduction was 9% and 14%, respectively. Splitting of nitrogen in three stages (treatment T2) compared to division in four stages (treatment T1) decreased nitrogen (12.8%) and seed protein (13%). The highest uptake of zinc was observed in T1N1 treatment in the first year, but in the second year, there was no statistically significant difference in the zinc uptake between the treatments. The comparison of the average quality traits in two years of the experiment showed that in the second year, in addition to the decrease in seed yield due to rainfall, the quality traits (including the nitrogen uptake and seed protein) also decreased.
Conclusions: Overall, splitting nitrogen in four equal usage can help to increase the quantitative and qualitative traits of corn, but it causes runoff losses. Therefore, considering these two conditions, T1N2 treatment is suggested as a suitable treatment due to the favorable grain yield, quality traits, water and nitrogen fertilizer efficiency and lack of runoff losses.
References:
The present study was conducted in the research field of Seed and Plant Improvement Research Institute to investigate the effect of fertilizer amount in three levels (N1: 100, N2: 80, N3: 60 percent of fertilizer requirement) and two splitting methods (T1: four equal usage including 4-6 leaf stage, 10 leaf stage, reproduction stage and inoculation stage and T2: three equal usage including 4-6 leaf stage, 10 leaf stage and reproduction stage) on corn yield and yield components. The treatments were compared with control which is the common fertilizer usage in the region. Based on the results, the highest grain yield in the first year was obtained in T1N1, T1N3 and control treatments. Grain yield in T2 was less than T1. Nitrogen splitting in T2 compared to T1 reduced the nitrogen content and grain protein content by 12.8% and 13%, respectively. Splitting of nitrogen fertilizer in three stages caused more nitrogen uptake by crop leaves at the end of the growing season; however, this did not increase grain yield and seed quality. Except for the control, no significant changes in soil nitrogen content were observed from surface to depth. The highest percentage of soil nitrogen was observed in the two layers of 0-20 and 20-40 cm in the control. The lowest content of soil nitrogen was observed in in T2N3 treatment with 24.5% (0-20 cm) and 24.5% (20-40 cm) more than control, respectively. The highest and lowest nitrogen losses in runoff were observed in T1N1 (23%) and control (7%), respectively. With the reduction of fertilizer application, runoff losses also decreased; in the T1N2 and T1N3 treatments, this reduction was 9% and 14%, respectively. Overall, T1N2 is recommended as a suitable treatment due to the high grain yield, seed quality and reduction of nitrogen losses.
Background and Objectives: Although reducing the amount of nitrogen fertilizer can lessen the negative effects of its losses, but it reduces the yield and yield components of crops, including corn (1). Therefore, nitrogen splitting is considered as a suitable solution to combat the reduction of nitrogen fertilizer consumption (2). Corn is one of the most important grains in the world, which can be cultivated in most regions of the world. As the third most consumed grain in the world, this crop has a share of about 2.8% of grain consumption in the world. This crop is cultivated in most provinces of the country and is sensitive to nitrogen (3) consumption. Increasing available nitrogen improves seed yield and growth indicators.
Methods: To achieve this goal, the present study was carried out in the research field of Seed and Plant Improvement Research Institute on fertilizer amount in three levels (N1: 100, N2: 80, N3: 60 percent of fertilizer requirement) and two splitting methods (T1: Four equal usage including 4-6 leaf stage, 10 leaf stage, reproduction stage and inoculation stage and T2: three equal usage including 4-6 leaf stage, 10 leaf stage and reproduction stage) in two years. These treatments were compared with control which was the traditional fertilizer usage in the region. The planting operation of this variety was done in May every year with a density of 80 thousand plants per hectare. Irrigation was done based on the complete water requirement of the plant. To determine the amount of irrigation water, evaporation from the surface of class A pan and application of pan and plant coefficients were considered. Irrigation was done in the form of furrows and according to the custom of the region, with a cycle of seven days. For this purpose, five wells were considered for each treatment. Three middle furrows were considered for harvest and two side furrows were considered for the marginal effect. The distance between the stacks was 75 cm and their length were 115 meters. Irrigation treatments were applied 5 days after planting.
Results: The highest grain yield in the first year was obtained in T1N1, T1N3 and control treatments. Grain yield in T2 was less than T1. Nitrogen splitting in T2 compared to T1 reduced nitrogen and grain protein by 12.8% and 13%, respectively. Splitting of nitrogen fertilizer in three stages caused more nitrogen uptake by crop leaves at the end of the growing season; however, this did not increase grain yield and seed quality. Except for the control, no significant changes in soil nitrogen content were observed from surface to depth. The highest soil nitrogen content was observed in the two layers of 0-20 and 20-40 cm in the control. The lowest soil nitrogen content was observed in T2N3 treatment with 24.5% (0-20 cm) and 24.5% (20-40 cm) more than control, respectively. The highest and lowest nitrogen losses in runoff were observed in T1N1 (23%) and control (7%), respectively. With the reduction of fertilizer application, runoff losses also decreased, so that in T1N2 and T1N3 treatments, this reduction was 9% and 14%, respectively. Splitting of nitrogen in three stages (treatment T2) compared to division in four stages (treatment T1) decreased nitrogen (12.8%) and seed protein (13%). The highest uptake of zinc was observed in T1N1 treatment in the first year, but in the second year, there was no statistically significant difference in the zinc uptake between the treatments. The comparison of the average quality traits in two years of the experiment showed that in the second year, in addition to the decrease in seed yield due to rainfall, the quality traits (including the nitrogen uptake and seed protein) also decreased.
Conclusions: Overall, splitting nitrogen in four equal usage can help to increase the quantitative and qualitative traits of corn, but it causes runoff losses. Therefore, considering these two conditions, T1N2 treatment is suggested as a suitable treatment due to the favorable grain yield, quality traits, water and nitrogen fertilizer efficiency and lack of runoff losses.
References:
1. Abbasi, F., Chogan, R., Gheibi, M. 2015. Investigating the possibility of reducing nitrogen losses in corn under furrow fertigation. Final Report of The Research Project. (In Persian)
2. Sadeghi, S.M., Noorhosseini, S.A., Damalas, Ch.A. 2018. Environmental sustainability of corn (Zea mays L.) production on the basis of nitrogen fertilizer application: The case of Lahijan, Iran. Renewable and Sustainable Energy Reviews 95: 48–55.
3. Tavangar, M., Eshghizadeh, H.R., Gheysari, M. 2020. Evaluation of late maturing corn hybrids for yield and water use efficiency under different irrigation regimes and split-application of nitrogen fertilizer. Journal of Water and Soil Science 24(2): 235–249. (In Persian with English abstract)
2. Sadeghi, S.M., Noorhosseini, S.A., Damalas, Ch.A. 2018. Environmental sustainability of corn (Zea mays L.) production on the basis of nitrogen fertilizer application: The case of Lahijan, Iran. Renewable and Sustainable Energy Reviews 95: 48–55.
3. Tavangar, M., Eshghizadeh, H.R., Gheysari, M. 2020. Evaluation of late maturing corn hybrids for yield and water use efficiency under different irrigation regimes and split-application of nitrogen fertilizer. Journal of Water and Soil Science 24(2): 235–249. (In Persian with English abstract)
Keywords: Furrow irrigation, Fertilizer losses, Fertilizer stress, Fertilizer irrigation, Grain nitrogen.
Type of Study: Research |
Subject:
Availability of soil water and nutrients for plant
Received: 2022/12/28 | Accepted: 2023/03/4 | Published: 2023/03/18
Received: 2022/12/28 | Accepted: 2023/03/4 | Published: 2023/03/18
Send email to the article author
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
Journal of Soil and Plant Interactions by http://jspi.iut.ac.ir is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
This work is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License which allows users to read, copy, distribute and make derivative works for non-commercial purposes from the material, as long as the author of the original work is cited properly.
This work is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License which allows users to read, copy, distribute and make derivative works for non-commercial purposes from the material, as long as the author of the original work is cited properly.
